Vmax Fitness Pro Case Removal Instructions
Step 1 Flip Vmax Pro over onto its bottom and make sure it rests on the black step plate. Step 2 Remove the screws that fasten the case to the base. There is a screw in the front of the snout not shown in picture.
|
|
Step 3 Carefully peel off the matt to reveal the bolt holding the platform to the base machine. The matt is taped to the platform with double sided tape. Remove the hex screws to release the platform from the base. |
|
Step 4 Remove the screw holding the 2 ground wires. DOUBLE CHECK that the ground wire from the NEW case is attached back to this screw!! Make sure the controller cable is placed through and under the small "nub" or opening. If not, the case will cut the cable when the screws are in. |
|
Step 5 Remove the RED / BLACK cable on the LEFT side of the
switch, looking from the inside. The GREEN grounding cable cannot
be removed from the switch. Please refer to Step 4 to remove
grounding wire from base.
|
|
Step 6 Remove the power switch first. From the inside of case, squeeze the two latches on the side and push forward to release the switch from the case.
|
|
Switch button is removed. Part of the power plug is removed also. Refer to step 7 for instructions. | |
Step 7 There are 4 latches on the power plug and may take some effort to remove. 2 latches are located on the top, and 2 on the bottom. Use something flat (HEX key provided in toolkit) to press down on the latch while simultaneously pushing forward on the switch on from rear.
|
|
All 4 corners pushed forward, power plug can be removed from the case | |
Both buttons removed. |